The Eufy QR code not functioning properly during setup process presents a common problem which can be resolved through basic troubleshooting steps. The QR code is required to connect your camera to Wi-Fi so every minor error will disrupt the authentication procedure.
You can resolve the Eufy QR code not working problem by following these steps:
1. Adjust Screen Brightness
You should increase your phone brightness until it reaches 100 percent. The camera system requires a bright display to scan the QR code because a dim display will stop scanning.
2. Clean the Camera Lens
Scanning will be obstructed by any dust or smudges on the lens. You should gently wipe the area using a soft cloth.
3. Correct Distance
You should maintain a distance of 6 to 8 inches between your phone and the camera. The scanning process fails because the distance between the two devices becomes either excessive or insufficient.
4. Check Wi-Fi Band
You need to connect to a 2.4GHz Wi-Fi network because most Eufy devices do not operate on 5GHz Wi-Fi networks.
5. Update the App
You need to confirm that your Eufy Security app exists in its latest form before you begin the setup process.
6. Verify Eufy Security Login
You need to check that your Eufy security Camera login credentials are valid while your account remains active.
You should perform a device reset followed by a complete setup restart if the problem persists. These steps usually resolve the problem quickly.